Dear Customers,

The PolySync Support Center is now just for submitting tickets to our support team. All articles and tutorials have been moved to the new PolySync Help Center and the content below will be removed shortly.

Thank you,
The PolySync Team

Delphi SRR / RSDS

General

Interface name
  • delphi-rsds
  • delphi-srr
Interface file
  • libps_delphi_rsds_left_interface.so
  • libps_delphi_rsds_right_interface.so
  • libps_delphi_srr_left_interface.so
  • libps_delphi_srr_right_interface.so
Supported Since
  • v2.0.0.b.1
OEM Hardware/Software/Firmware Version  
Sensor Communication Protocol  
PolySync Sensor Type
  • 140
Driver Notes
  • SDF sensor configuration's serial number must match the sensor's serial number in order to validate
  • -c use provided CAN channel system index instead of what is stored in the SDF [optional]
  • -t perform a validation test on the Delphi interface [optional]
  • -g get the sensor identifier address from the Delphi interface [optional]

(OEM) Sensor Description

PolySync Configuration

  • Locate CAN hardware and circuit identifiers.
  • Copy these numbers into SDF configuration
  • Run driver

For more information check out the parsing sensor identifiers article.

Interface Requirements

Input Message Types

Input Msg Type
Notes
Native CAN message stored as ps_can_frame_msg Default bit rate: 500K

Output Message Types

Output Msg Type
Notes
ps_radar_targets_msg Radar tracks

Command Line Arguments

  1. -h show this help message [optional]
  2. -o enable output of log messages to stdout (in addition to syslog) [optional]
  3. -w disable the hardware interface(s), allowing the node to run without hardware connected [optional]
  4. -r SDF runtime configuration key that specifies the domain to operated under, the default domain is used otherwise [optional]
  5. -n SDF node configuration key for the node [required]
  6. -i use provided PAL interface file instead of what is stored in the SDF [optional]
  7. -e export a JSON support string describing the interface, used by the SDF configuration tool [optional]
  8. -c use provided CAN channel system index instead of what is stored in the SDF [optional]
  9. -t perform a validation test on the Delphi interface [optional]
  10. -g get the sensor identifier address from the Delphi interface [optional]

Events

If applicable, list events published and under what circumstances they are published

Event ID
Event Description
Implemented (y/n)
Active When
Notes
N/A N/A

Parameters

Parameter ID
Description
Notes
800 Active Coordinate Frame Identifier  
810 Output Field of View Range  
1002 Sensor 0 X Position Meters
1003 Sensor 0 Y Position Meters
1004 Sensor 0 Z Position Meters
1005 Sensor 0 Roll Orientation Degrees
1006 Sensor 0 Pitch Orientation Degrees
1007 Sensor 0 Yaw Orientation Degrees
1001 Sensor 0 Identifier Serial number
400 CAN Channel 0 Hardware Identifier  
401 CAN Channel 0 Circuit Identifier  

Other resources

 

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.